gateways_17_cli_hg3500v4.fm
Command Line Interface CLI in HG 3500
Access control
17.3 Access control
17.4 Gateway Setup
150
•
The configuration write access has to be acquired before a store, upload or
download command can be done. Because of the implemented "soft lock"
handling, at first a check if somebody else has set the write access is
required.
who has write access
get write access
release write access
To permit system initialisation and basic management configuration activities
following commands are needed.
•
Setting and changing the gateway name:
set hostname <hostname>
•
Setting and changing the IP-Address for the ethernet port:
set ip address
set ip subnet
A set or a change of the IP-address or IP subnet for the ethernet port will
probably require a gateway reboot to become effective.
•
Setting and changing the IP-address of the default gateway from static routes
table:
set default gateway
•
Display/change choosen identifier:
get id <parameter name>
set id <parameter name>
hostname
The parameter hostname > terms an arbitrary name for the gateway and it must
be a string of characters (e.g. set hostname Gateway1). It corresponds with the
boot line parameter "targetname".
ip address
The parameter <ip address> is a string in the form of x.x.x.x and x is an integer
(e.g. 1.2.3.4)
HiPath 4000 V5, IP Solutions - HG 3500 & HG 3575, Service Documentation
address>
<ip
<ip subnet
mask>
address>
<ip
A31003-H3150-S104-2-7620, 03/2009