Table of Contents
Advertisement
gateways_13_hg3500v4_install_hints.fm
General Information on How to Configure a HG 3500 V4 Common Gateway
Rules
If the value BCHAN60&BCHAN120 is set, an STMI
used. This value is also useful if a small STMI with 60 B channels becomes defective. This
can then be replaced with a large STMI with 120 B channels. It is not possible to replace
a large STMI with a small one.
Parameter UNITS
●
–
1 unit corresponds to 10 B channels
–
If the number of units (UNITS) is not specified for the configuration, 10 B channels
(UNITS=1) are configured for each circuit.
–
Up to three units can be specified for each circuit.
–
The total number of B channels for the function is calculated by multiplying the number
of circuits (LINECNT) by the number of B channels in a unit (UNITS).
Example: LINECNT=4, UNITS=3. 4 multiplied by 3 multiplied by 10 equals 120 B chan-
nels.
If an IPDA function (HG3570) is to be configured for a multiple feature configuration, this
●
must be configured first.
For IPDA, only the number of B channels (BCHLCNT) must be specified.
●
For IP trunking, the number of circuits (LINECNT) and the number of units (UNITS) must
●
be specified.
For HFA and SIP, the number of circuits (LINECNT) and the number of B channels (BCHL-
●
CNT) must be specified.
If reserved HFA or SIP circuits are to be configured, the B channels designated
>
for this purpose must also be specified here.
This is not necessary for reserved trunk circuits as the assignment is performed
based on the number of units (UNITS).
For WAML, only the number of units (UNITS) must be specified.
●
Only one circuit is possible for WAML.
>
This parameter can be omitted if UNITS=1.
Reserve function
●
1. STMI stands for STMI2 (Q2316-X, Q2316-X10) and STMI4 (Q2324-X500,Q2324-X510)
120
HiPath 4000 V5, IP Solutions - HG 3500 & HG 3575, Service Documentation
1
with 60 or 120 B channels can be
A31003-H3150-S104-2-7620, 03/2009
Advertisement
Table of Contents
