Table of Contents
Advertisement
gateways_12_hg3575v4.fm
HiPath Gateway HG 3575 V4 - Changing Parameters with AMO STMIB
TYPE DLSDATA - Configuring DLS Data
12.14 TYPE DLSDATA - Configuring DLS Data
12.15 Resetting the Parameters to Default Values
116
Configuration Management --> System Data --> IPDA --> IPDA Access
Point
Click Search and select the access point.
Enter the Gateway Sector Number on the General tab and click Save.
CHANGE-
STMIB:MTYPE=NCUI2,LTU=99,TYPE=GWSECTOR,GWSECTNO=7;
This change becomes effective immediately and without interrupting operation.
CHANGE-STMIB:MTYPE=NCUI2,LTU=99,TYPE=DLSDATA,DLSIPADR=<number>,
DLSPORT=<number>,DLSACPAS=<param>;
If the parameters of one or all branches of the NCUI2/4 data are to be reset to
default values, e.g. after being changed temporarily for diagnostic work, this can
be performed in the INITNCU2 branch. The example sets all ASC parameters to
their default values.
Initialization can only be initiated in expert mode.
Expert Mode --> HiPath 4000 --> HiPath 4000 Expert Access --> Open
...<IP> with AMO
(see AMO command)
CHANGE-STMIB:MTYPE=INITNCU2,LTU=17,TYPE=ASC;
The changes under TYPE ASC, DSP, H323, JB, SNMP, MGNTDATA, WBMDATA
and DLSDATA become effective immediately without interrupting operation.
Changes under TYPE GLOBAL, IFDATA, SERVIF, DMCDATA and SIGQOS
become effective after the access point has been restarted.
This behaviour is also valid for the command CHANGE-
STMIB:MTYPE=INITNCU2,LTU=17, TYPE=ALL;. Therefore it is
recommended to restart the access point after resetting all parameters.
HiPath 4000 V5, IP Solutions - HG 3500 & HG 3575, Service Documentation
A31003-H3150-S104-2-7620, 03/2009
Advertisement
Table of Contents
