Configuration; Special Use Cases - Siemens HG 3500 V4 Service Manual

8.3 Configuration

8.4 Special Use Cases

A31003-H3150-S104-2-7620, 03/2009
HiPath 4000 V5, IP Solutions - HG 3500 & HG 3575, Service Documentation
Loadware Update via HiPath 4000 Assistant / WBM: backup server
configured and reachable, but on the backup server an older configuration
than the current one is found
Same as„Loadware Update via HiPath 4000 Assistant / WBM".
The feature will be configured with the WBM of the board.
WBM > Maintenance > Actions > (double-click) Automatic Actions > Saving
Local Configuration for Upgrade
• Board replacement
The new board has already a stored backup file in the local flash (but with
another functionality than the one that will be replaced).
Because there is a backup file in the local flash it will be used for restoring the
data. But because of the board replacement the MAC address of the board
has changed. Therefore HiPath Backup & Restore is contacted to perform a
restore with the backup file of the backup server. After the restore from the
backup server the correct data is configured on the board. In this case the
backup server must be reachable otherwise the board has stored the wrong
configuration data.
After the restore the backup of the local flash should be updated with the
current configuration data.
• Default configuration (empty data base)
An empty data base can be configured as follows:
WBM > Maintenance > Configuration > (right mouse) Reset Configuration
to Factory Default ...
With choosing this option the board will be reseted automatically. During the
startup of the board the parameters configured via AMO will be loaded. The
WBM parameters will be set to default.
gateways_08_local_flash.fm
Save Configuration Data in Local Flash
Configuration
77