Table of Contents
Advertisement
gateways_10_standby.fm
Standby Board HG 3500
Relevant AMOs
102
AMO
Parameter
SMODE
IPADR
IPADR
NETMASK
NETMASK
FUNSU
AKTION
ACTION
HiPath 4000 V5, IP Solutions - HG 3500 & HG 3575, Service Documentation
Sprache/
Beschreibung/ Description
Language
e
Standby Mode or Normal Mode
NORMAL: A board in Normal Mode has valid
board data and normally also OPTIIPs
STDBYRDY: A board in Standby Ready Mode
has no valid board data, to this board OPTIIPs
can be switched over if another board of the
same board reconfiguration pool (AMO
BPOOL) becomes defective.
STDBYDEF: A board in Standby Defect Mode
has also no valid board data, this board has lost
its OPTIIPs and its board data to another board
because it's gone defective.
d
IP Adresse der Common Gateway Baugruppe
e
Source IP address of common gateway board
d
IP-Netzmaske des LAN-Segmentes. Die IP-
Netzmaske bestimmt die Grenze zwischen
Netz- und Host-Teil in der IP-Adresse. Alle IP-
Adressen am LAN-Segment müssen bezüglich
des Netzanteils der IP-Adresse gleich und
bezüglich des Host-Teils unterschiedlich sein
(auch der Default Router muss dieser
Bedingung entsprechen).
e
IP net mask of LAN segment The IP net mask
determines the network and the host partition of
an IP address. All IP addresses of a LAN
segment must contain the identical network
addresss part but different host address parts
(also the Default Router must fulfill this
d
Ladeart der Baugruppe: Damit der LW Code
nicht bei jedem Baugruppen-Reset geladen
wird, sollte RESET eingestellt sein.
e
Action set or reset loadware on board:
In order to avoid loading of the LW code, it is
recommended to set this parameter to RESET.
A31003-H3150-S104-2-7620, 03/2009
assigned to it.
(Source Adresse)
requirement)
Advertisement
Table of Contents
