Panel Mounting - JUMO miroTRON Brief Instructions

4.3

Panel mounting

CAUTION!
The front of the device and housing have different protection types!
The protection type IP65 (front-side) is only guaranteed if the seal is flush and even.
 Use the mounting frame or both mounting elements as shown in the figure and ensure an even at-
tachment!
1 Device
3 Seal and case front
5 Mounting frame
1. Create panel cut-out 69 +1 mm x 28.5 +1 mm.
2. Insert the device from the front into the panel cut-out and ensure that the seal is correctly positioned.
3. Push the mounting frame from the panel rear onto the device body and press the springs against the
panel rear until the detent lugs engage in their slots and the frame is sufficiently fastened.
The detent lugs of the mounting frame slot into the mounting slots of the housing upper and lower side.
The device is mounted mechanically.
NOTE!
The electrical connections should not be established until the mounting frame has been slid onto the de-
vice.
(1) (2)
(5)
2
4
6 9 + 1
(4)
Panel
Panel cut-out
4 Mounting
(3)
17