Test Set-Up; Test - BOMBARDIER Chalenger 604 Supplemental Maintenance Manual

3. T S -
EST ET UP
A. Configure aircraft in standard configuration for maintenance.
4. T
EST
A. Operational Test of the Throttle Controls
(1) Perform CL-604 AMM Task 76-10-00-710-801, Operational Test.
NOTE: If the throttle controls fail to meet any of the requirements of the operational test of the
throttle controls, perform CL-604 AMM Task 76-10-00-720-801, Functional Test of the
Throttle Controls.
NOTE: If the throttle controls fail to meet any of the requirements of the functional test of the
throttle controls, perform CL-604 AMM Task 76-10-00-820-801, Rigging of the Throttle
Controls.
B. Friction Test of the Throttle Controls
(1) Operate each throttle lever through travel range a minimum of six (6) times.
(2) Ensure the operation is smooth and does not bind.
(3) Perform the throttle control friction test per CL604 AMM Task 76-10-00-720-802, except that
breakout forces must not exceed 6.5 ft.-lb. and operational forces must not exceed 6.5 ft.-lb.
Omit S76-10-00-720-006, with friction damper at maximum. Friction damper will be fixed at
minimum per TM432230-10-3.
C. Fuel Control Rigging Test
NOTE: Perform the following procedure for both left and right throttle controls.
(1) Verify that throttle control gearbox and main fuel control rig pins can be inserted per CL-604
Task 76-10-00-710-801, Operational Test of the Throttle Controls. Perform steps 1, 4, 5, and
7 of the procedure.
NOTE: When performing step 7 (i), ensure that the quadrant friction is adjusted to full OFF
(2) Verify correct fuel control lever angle per CL-604 Task 76-10-00-720-801, Functional Test of
the Throttle Controls. Perform step 5 (a) (do not connect AC power), step 6 (a) to (i), and
step 11 of the procedure.
NOTE: When performing step 6 (d) ensure the quadrant friction is adjusted to full OFF and
(3) If the throttle control fails to meet any of the above requirements, perform CL-604 Task
76-10-00-820-801, Rigging of the Throttle Controls.
NOTE: CL-604 AMM does not reference the ATS. The forward throttle cables attach to the
EFFECTIVITY: TE-22305001-SMM-2
CL-604 SUPPLEMENTAL MAINTENANCE MANUAL
Prepared by DAS-605786-NM
and the throttle lever stays hard against the stop.
the throttle lever stays hard against the stop.
input arms to the ATS clutch pack. If forward throttle cable adjustments are required,
22-30-00
Page 503
Dec 3/03