Adjustment/Test - BOMBARDIER Chalenger 604 Supplemental Maintenance Manual

D. To install the clutch pack assembly
NOTE: A rigging check and adjustment is required after replacement of the clutch pack assembly.
NOTE: The shaft is a two-part assembly. Do not allow the two parts to become axially separated.
(1) Support the clutch pack assembly and position onto the stub shaft of the servo drive.
(2) Using the modified 3mm Allen wrench (see Safe Flight Repair Procedure R2830), install the
six screws attaching the shaft flange to the servo drive sub-assembly.
(3) While supporting the assembly, install the remaining servo drive sub-assembly (Step
above).
(4) Install the four pivot pins that connect the clutch servo arms to the control rods and control
links.
NOTE: Read the adjustment procedures before securing the pivot pins.
(5) Install new retaining rings and cotter pins on each pivot pin.
(6) Verify proper adjustment of auto throttle system in accordance with SMM 22-30-00,

ADJUSTMENT/TEST.

(7) Restore power (AMM Task 24-00-00-861-801) and verify proper operation of auto throttle
system in accordance with SMM 22-30-00, ADJUSTMENT/TEST.
E. To install a bell crank assembly
NOTE: A rigging check and adjustment is required after replacement of a bell crank assembly.
NOTE: The left (pilot) and right (copilot) bell cranks are not interchangeable. The outside end of
the bell crank shaft is stamped with -1 or -2 to indicate left or right, respectively.
(1) Position bell crank assembly inner arm into the support structure.
(2) Install the four Allen-head screws attaching the bell crank assembly to the support structure.
(3) Connect the outer arm of bell crank assembly to the push-pull engine cable (AMM Task
76-00-04-400-801).
(4) Connect the inner arm of bell crank assembly to the control link and insert the pivot pin.
NOTE: Read the adjustment procedures before securing the pivot pins.
(5) Install new retaining ring and cotter pin on pivot pin.
(6) Verify proper adjustment of auto throttle system in accordance with SMM 22-30-00,
ADJUSTMENT/TEST.
(7) Restore power (AMM Task 24-00-00-861-801) and verify proper operation of auto throttle
system in accordance with SMM 22-30-00, ADJUSTMENT/TEST.
EFFECTIVITY: TE-22305001-SMM-2
CL-604 SUPPLEMENTAL MAINTENANCE MANUAL
Prepared by DAS-605786-NM
(Figure 401):
(Figure 401, Figure 403):
22-30-00
2.C.
Page 405
Dec 3/03