Advertisement
PLACARDS AND MARKINGS - REMOVAL/INSTALLATION
1.
R
EMOVAL
A.
To remove the self-illuminated exit sign:
WARNING: RADIOACTIVE MATERIAL - THE RECEIPT, POSSESSION, USE, AND TRANSFER
OF THIS DEVCE IS SUBJECT TO A GENERAL LICENSE OR THE EQUIVALENT,
AND THE REGULATIONS OF THE U. S. NUCLEAR REGULATORY COMMISSION
(NRC), OR A STATE WITH WHICH THE NRC HAS ENTERED INTO AN
AGREEMENT FOR THE EXERCISE OF A REGULATORY AUTHORITY. DO NOT
ABANDON OR DISPOSE OF THIS SIGN EXCEPT BY TRANSFER TO PERSONS
SPECIFICALLY LICENSED BY THE NRC OR AN AGREEMENT STATE.
NOTE: Typically, the self-illuminated exit sign is located on the aft side of forward cabin bulkhead.
NOTE: The sign is secured to the bulkhead with self-adhesive material.
(1)
Use a spatula or a knife to lift a corner of the sign.
(2)
Carefully pull the sign away from the mounting surface.
(3)
Discard the self-illuminated exit sign in accordance with the instructions included with the
replacement sign.
2.
I
NSTALLATION
A.
To install the self-illuminated exit sign:
(1)
Use a clean, low-lint cloth, moist with the TT-N-95 solvent, to clean the area specified for
installation of the placard (AMM TASK 51-25-00-110-801).
(2)
Remove the protective backing layer from the sign. Discard the protective backing layer
after removal.
(3)
Put the sign in position at the mounting location.
(4)
Apply pressure to the sign to secure it to the bulkhead.
(5)
Remove all tools, equipment, and unwanted materials from the work area.
TE-55965000-SMM
EFFECTIVITY:
Revision A
CL-604 SUPPLEMENTAL MAINTENANCE MANUAL
11-00-01
Nov 10/2006
Page 401
Hide quick links:
Advertisement
Chapters
