Operation - BOMBARDIER Chalenger 604 Supplemental Maintenance Manual

FLOOR ACCENT LIGHTS
FLOOR ACCENT LIGHTS - DESCRIPTION/OPERATION
1. D /L
ESCRIPTION OCATION
NOTE: See 20-12-00 for light strip replacement instructions.
Lighting strips have been installed to provide floor accent lighting in the main cabin, entry area, and aft
lavatory. Table 1 lists the components and their locations.
Control of the components listed in
Modules 1 and 2 (CCM 1 and CCM 2) (23-90-00).
Component (Qty)
CABIN FLOOR LIGHTS switches (2)
GALLEY FLOOR LIGHTS switch
Incandescent lighting strips (6)
LAV FLOOR LIGHTS switches (2)
Relay K1LR
GALLEY LAV ACCENT circuit breaker CBPG-1
CABIN FLOOR circuit breaker
2. O
PERATION
Press one of the CABIN FLOOR LIGHTS switches to send a signal via the cabin data bus to CCM 1,
which energizes relay K1LR, sending power to the cabin lighting strips. Press the switch again to send a
signal via the cabin data bus to CCM 1, which de-energizes relay K1LR, removing power from the cabin
lighting strips.
Press one of the LAV FLOOR LIGHTS switches to send a signal via the cabin data bus to CCM 2, which
sends power to the lavatory lighting strips. Press the switch again to send a signal via the cabin data bus
to CCM 2, turning off the lavatory lighting strips.
Press the GALLEY FLOOR LIGHTS switch to send a signal via the cabin data bus to CCM 1, which
sends power to the galley lighting strip. Press the switch again to send a signal via the cabin data bus to
CCM 1, removing power to the galley lighting strip.
TE-55965000-SMM
EFFECTIVITY:
Revision A
CL-604 SUPPLEMENTAL MAINTENANCE MANUAL
Table 1 is managed by cabin management system Cabin Control
Galley and VIP Switch Panels
Galley Switch Panel
Below air ducts in main cabin; below toilet enclosure;
below galley and vanity kick panels. See floorplan layout
graphic.
Lavatory and Galley Switch Panels
Behind dado panel at RH chair 2
CBPG-4
FLOOR ACCENT LIGHTS COMPONENTS AND LOCATIONS
Location
TABLE 1
33-22-01
Page 1
Nov 10/2006