Table of Contents
Advertisement
PRESYS
Instruments
2.2 - Menu CONF
CF: Selects the temperature unit between ºC or ºF. The ITS-90 or IPTS-68
temperature scales are selected for both the thermo-element and for the internal block
reference readings purpose.
LCD: This option sets the graphic liquid crystal display contrast. Use the key
and
until you get a better contrast and finish the operation by pressing the key
ENTER.
BT: Shows the battery or the battery charger voltage value if the dry block is
turned off or on, respectively.
Battery Level
4.0 a 7.0V
< 4.0V
DT: Updates the date and time of the calibrator. Thus, when the calibrator
performs a calibration in the automatic mode via ISOPLAN-5, all data are registered
together with date and time of occurrence. Every time the calibrator is powered off, the
internal clock does not continue to be updated. However, the ISOPLAN-5 software can
automatically update the calibrator date and time with the computer internal clock.
Otherwise, use keys
go to another field. The key ENTER confirms the last selection.
BZ: Menu that configures the piezoelectric buzzer.
NO: Disables the buzzer.
YES: The buzzer beeps when the block reaches the set point and stabilizes.
ENDCAL: The buzzer beeps only at the end of a calibration in the automatic
operating mode.
PRG: Menu that programs the calibrator.
DEC_IN: Selects the number of decimals of the thermo-element reading. The
default value depends on the input signal.
CF
PRG
SC
BT
ºC-90
ºC-68
Estado da bateria
and
to change the field that blinks and the keys
NO
YES
DEC_IN
SET POINT
TE -25N / TE-35N / TE-50N
MEM
LCD
DT
BZ
ºF-90
ºF-68
normal
low
ENDCAL
DEC_PRB
Display
----------
LOW BATTERY
and
to
Page 11
Advertisement
Table of Contents
