Table of Contents
Advertisement
PRESYS
Instruments
2.3 - Manual Operating Mode
The display shows the selected temperature
There are 4 ways in which the information are shown, covering the calibrator input
value (IN), the block temperature (PROB) and the temperature set point (SET). The key
interchanges the display presentation way:
The block temperature set point is selected directly by the keypad, even if the
message SET is not being displayed. The numeric keypad enables the SET
selection in any of the display presentation ways, to change the set point.
The set point value is increased by key
the keys are kept pressed, the set point continues to be increased or decreased.
The key
25N/TE-35N/TE-50N calibrator.
2.4 - Programmable Operating Mode
Pre-configured programs can be load from the calibrator memory, enabling the
programmable operating mode. The temperature programmed values of the block are
used directly, with no need to enter the set poit.
The display shows STEPn beside the block temperature set point value in the
programmable mode. The number of the program is indicated by n. Using the keys
and
, the programmed values of temperature set point are changed. The numeric
keypad continues available for manual selection of the block temperature in the same
way of the manual operating mode.
The automatic scan over the programmed temperatures is implemented by
defining the stabilization time of the thermoelement in the block.
The key
enables the automatic scan over the points. When pressed, the message
STEPn gives place to 0s and the calibrator waits for the stabilization time configured from 1
to 9 minutes, by the keys 1 to 9. The automatic scan is disabled by pressing key
Page 14
IN = 23.456 mV
PROB= 25.01 ºC
PROB= 25.01 ºC
SET = 25.00 ºC
23.456
IN = Voltage (mV)
25.01
SET = 25.00 ºC
does not have function in the manual operating mode of the TE-
TE -25N / TE-35N / TE-50N
and decreased by key
. While
again.
Advertisement
Table of Contents
