Advertisement
HEIGHT CONTROL INSTRUCTIONS
UP button
LED display
DOWN button
ADJUST HEIGHT
Press UP or DOWN button. Display shows the current height.
MEMORY FUNCTION
Press UP or DOWN button to adjust the desk to the required
height. Press MEMORY button to store the height. The display
will show
. Now press a POSITION button to store the height
on preset 1, 2 or 3. The display will show
POSITION preset button to adjust the desk to the saved height.
ANTI-COLLISION SENSITIVITY
Press UP and DOWN buttons at the same time to adjust the
sensitivity of the anti-collision system. 3 levels of sensitivity are
available, low
, medium
TROUBLESHOOTING
Symptom
No response from a long press of the DOWN
1
button after power is connected.
2
Desk does not lift when up button is pressed.
Cuts out during use.
3
Display shows 'E01' or 'E02' .
4
Desk will not go high enough or low enough.
5
Display shows
SAFETY
Assembly
• Only to be assembled by a competent person - check carefully for complete and correct assembly before use.
• Dispose of packaging in an environmentally-friendly manner. Recycle cardboard and paper.
• Keep plastic and small parts out of the reach of children. Danger of suffocation/choking.
Product care
• Unplug before servicing and cleaning.
• Wipe surfaces with a damp microfibre cloth - do not spray cleaner near electrical parts or connections.
• Do not use chemical or abrasive cleaners.
• Do not leave work surface wet.
• Use a drinks coaster to prevent marks.
• Use a mouse mat to prevent abrasion of the work surface.
End of life disposal
• This product must be recycled in accordance with WEEE directives.
POSITION preset buttons
ALERT button
MEMORY button
,
or
. Press a
or high
.
Possible Cause
Cables not connected properly.
Power supply off.
Other fault.
Overloaded (maximum load 125kg
including desktop).
Power or connection fault.
Other fault.
Duty cycle exceeded 2 minutes on
- 18 minutes off.
Other fault.
Factory reset required.
Other fault.
Reset required.
TECHNICAL DATA
Column Number
Maximum Load
Maximum Speed
Input Voltage
Lowest Position
Highest Position
Desktop Size
Duty Cycle
Operating Temperature Range
REMINDER FUNCTION
Press ALERT button to activate. The display will show . Wait 2 seconds
for the display to flash then press the UP or DOWN button. The screen
will display
which is the default reminder duration of 45 minutes. Now
press any button to save this setup, or wait 5 seconds and the system
will save automatically. The timer will countdown to zero. During the
countdown press any button to reset the countdown timer. When it
reaches zero
the buzzer will activate with a 10 second tone. Within 10
seconds press any button to reactivate the countdown timer. If no button
is pressed during 10 seconds there will be another reminder buzzer after
5 minutes. If no button is pressed during the second buzzer the reminder
function will switch off automatically. Press and hold the ALERT button to
switch off the reminder function. The display will show
3
125kg
38mm/second
100-240v
580mm
1230mm
Width 1100-1900 mm
Depth 700 or 800mm
Continuous operation for 2 mins
at most after pause for 18 mins
0-40°C
.
Remedy
Check connections and retry.
Check power supply.
Contact your supplier.
Check and lighten load if necessary.
Check power supply and connections
in Symptom 1.
Contact your supplier.
Wait 30 minutes for the motors to cool
and retry.
Contact your supplier.
Press 'M' and '3' buttons together for more
than 3 seconds and wait for 2 long beeps.
Contact your supplier.
Press DOWN button until desk reaches it's
lowest position and rebounds to stop.
Advertisement
