EVAL-IMI111T user guide
iMOTION™ MADK starter kit for IMI111T IPMs
Getting started with EVAL-IMI111T
7.3
UART function switching
To use Pin1 and Pin2 as UART, users must ensure that the RXD0" and "RX/DIR" of jumper J2 are connected and
"TXD0" and "TX/PGOUT" of jumper J4 are connected.
To use Pin1 as PG_OUT and Pin2 as DIR, users must ensure that "PGOUT" and "TX/PGOUT" of jumper J4 are
connected and "DIR" and "RX/DIR" of jumper J2 are connected. In this case, connection to iSD is no longer
available.
Please refer to the document How to Use UART Interface of IMM101T and IMI111T [5] for information on how to
configure this function.
User guide
27 of 37
V2.1
2022-12-9