Getting Started With Imotion - Infineon EVAL-IMI111T User Manual

EVAL-IMI111T user guide
iMOTION™ MADK starter kit for IMI111T IPMs
Getting started with EVAL-IMI111T
Ensure the jumper on J2 is connected to "RXD0" and "RX/DIR" and the jumper on J4 is connected to "TXD0"
1.
and "TX/PGOUT".
Connect the PC-USB connector to the onboard debugger via the USB cable.
2.
Connect AC power and earth to J1.
3.
Connect motor to J3. Please note the sequence of U, V, and W phases and change the sequence of any two
4.
phases if the motor's running direction needs to be altered.
Method 2: Using an external debugger
Figure 24
Method 2: Using an external debugger
Follow these steps:
Ensure the jumper on J2 is connected to "RXD0" and "RX/DIR" and the jumper on J4 is connected to "TXD0"
1.
and "TX/PGOUT".
Remove the resistors R4 and R5 from the back of the board (R4 and R5 must be soldered for using the onboard
2.
debugger).
Connect PC-USB connector to iMOTION™ Link via the USB cable.
3.
Connect iMOTION™ Link to J7. Any plugging direction is okay for this board.
4.
Connect AC power and earth to J1.
5.
Connect motor to J3. Please note the sequence of U, V, and W phases sequence and change the sequence of
6.
any two phases if the motor's running direction needs to be altered.
7.2

Getting started with iMOTION™

Please refer to the document iMOTION™ Solution Designer [4] for information on how to use the iMOTION™
Solution Designer tuning tool.
User guide
AC
Earth
USB cable
J1
J7
26 of 37
J3
2022-12-9
V2.1