Table of Contents
Advertisement
EVAL-IMI111T user guide
iMOTION™ MADK starter kit for IMI111T IPMs
Getting started with EVAL-IMI111T
7
Getting started with EVAL-IMI111T
This chapter provides details on setting up the system and getting started with the iMOTION™ development
platform.
The iMOTION™ development tool, iMOTION™ Solution Designer is required to set up the system, and to control
and fine-tune the system performance to match a user's actual needs. This tool is available for download from
Infineon's website (http://www.infineon.com/imotion-software).
Isolated onboard debugger provides the USB-to-UART bridge between the PC and the target iMOTION™ device
with 1 kV DC galvanic isolation between the motor drive system (hot side) and the PC/debugger (cold side). This
onboard debugger uses the SEGGER J-Link driver for UART communication with the IMI111T device. The J-Link
driver is installed during the installation of the iMOTION™ Solution Designer. In case the driver is not installed
properly, please visit the
Documentation pack for Windows.
This board also provides the external debugger interface for iMOTION™ Link. Users can also use iMOTION™ Link
to debug this board instead of the onboard debugger. iMOTION™ Link is also isolated. For more information
about iMOTION™ Link, please visit the
7.1
Hardware connection
There are two methods to debug the board. One is to use the onboard debugger and another is to use the external
debugger, iMOTION™ Link. Before debugging, the board needs to be connected PC using either of these two
methods.
Method 1: Using onboard debugger
Figure 23
Method 1: Using the onboard debugger
Follow these steps:
User guide
SEGGER J-Link website
iMOTION™ Link
AC
Earth
USB cable
to download and install the latest J-Link Software and
page on Infineon's website.
J1
25 of 37
J3
2022-12-9
V2.1
Advertisement
Table of Contents
