Install The Front Operator Panel - Lenovo ThinkSystem SE350 Maintenance Manual

• "Safety" on page iii
• "Installation Guidelines" on page 37
2. Turn off the server. Disconnect the power cords and all external cables (see
page 16).
3. Remove the node from the enclosure if needed (see
4. Remove the M.2 WLAN/LTE wireless adapter if installed (see
adapter" on page 41).
5. Remove the lock position switch if installed (see
To remove the front operator panel, complete the following steps:
Watch the procedure
A video of this procedure is available at YouTube:
DkEpH4SzvKZck4f6rVRzUE
Step 1. Carefully remove the cable from the metal pull tab holder.
Step 2. Carefully press the cable latches and disconnect the two Y-cable connectors.
Step 3. Remove the screw.
Step 4. Pull the release tab.
Step 5. Slide the front operator panel out of the server.
Figure 53. Front operator panel removal
If you are instructed to return the defective component, please package the part to prevent any shipping
damage. Reuse the packaging the new part arrived in and follow all packaging instructions.

Install the front operator panel

Use this information to install the front operator panel.
Before you install the front operator panel, complete the following steps:
1. Read the following sections to ensure that you work safely.
• "Safety" on page iii
• "Installation Guidelines" on page 37
2. Turn off the server. Disconnect the power cords and all external cables (see
page 16).
To install the front operator panel, complete the following steps:
ThinkSystem SE350 and ThinkSystem SE350 Enclosures Maintenance Manual
68
"Remove the lock position switch" on page
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
.
"Remove a node" on page
"Remove the M.2 WLAN/LTE wireless
"Power off the server" on
98).
75).
"Power off the server" on