Install A Node - Lenovo ThinkSystem SE350 Maintenance Manual

Note: See Configuration Installation Guide for the bookshelf configuration, DIN rail
configuration and wall-mounted configuration installation details if necessary.
If you are instructed to return the defective component, please package the part to prevent any shipping
damage. Reuse the packaging the new part arrived in and follow all packaging instructions.

Install a node

Use this information to install a node.
Before you install a node, complete the following steps:
1. Read the following sections to ensure that you work safely.
• "Safety" on page iii
• "Installation Guidelines" on page 37
2. Make sure all the removed components are installed, and all the disconnected cables inside the server
are reconnected.
Watch the procedure
A video of this procedure is available at YouTube:
DkEpH4SzvKZck4f6rVRzUE
To install a node, complete the following steps:
Step 1. To install the node into the node sleeve, complete the following steps.
a. Align the node with the node sleeve and slide the node into place.
b. Fasten the two thumbscrews.
Note: See Configuration Installation Guide for the bookshelf configuration, DIN rail configuration
and wall-mounted configuration installation details if necessary.
Figure 103. Node installation
Step 2. To install the node into the enclosure, complete the following steps.
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
.
.
Chapter 3 Hardware replacement procedures
101