Change The Vpd For E1 Enclosure Configuration (Trained Technician Only) - Lenovo ThinkSystem SE350 Maintenance Manual

• From Lenovo XClarity Provisioning Manager
To enable UEFI Secure Boot from Lenovo XClarity Provisioning Manager:
1. Start the server and press the key specified in the on-screen instructions to display the Lenovo
XClarity Provisioning Manager interface. (For more information, see the "Startup" section in the LXPM
documentation compatible with your server at
lxpm_product_page.html
2. If the power-on Administrator password is required, enter the password.
3. From the UEFI Setup page, click System Settings ➙ Security ➙ Secure Boot.
4. Enable Secure Boot and save the settings.
• From Lenovo XClarity Essentials OneCLI
To enable UEFI Secure Boot from Lenovo XClarity Essentials OneCLI:
1. Download and install Lenovo XClarity Essentials OneCLI.
To download Lenovo XClarity Essentials OneCLI, go to the following site:
https://datacentersupport.lenovo.com/solutions/HT116433
2. Run the following command to enable Secure Boot:
OneCli.exe config set SecureBootConfiguration.SecureBootSetting Enabled
--bmc <userid>:<password>@<ip_address>
where:
– <userid>:<password> are the credentials used to access the BMC (Lenovo XClarity Controller
interface) of your server. The default user ID is USERID, and the default password is PASSW0RD
(zero, not an uppercase o)
– <ip_address> is the IP address of the BMC.
For more information about the Lenovo XClarity Essentials OneCLI
http://sysmgt.lenovofiles.com/help/topic/toolsctr_cli_lenovo/onecli_r_set_command.html

Change the VPD for E1 Enclosure configuration (trained technician only)

Use the following information to change the vital product data (VPD) for E1 Enclosure configuration.
If the node is to be installed in an E1 Enclosure (1U 2-node), change the vital product data (VPD) for proper
operation.
Important: This task must be operated by trained technicians.
To change the VPD for E1 Enclosure configuration, complete the following steps:
1. Enable IPMI on Lenovo XClarity Controller web interface or Lenovo XClarity Essentials OneCLI.
2. Implement the following IPMI commands:
ipmitool raw 0x3A 0x0C 0x0E 0x01 0x10 0x54 0x68 0x69 0x6e 0x6b 0x53 0x79 0x73 0x74 0x65 0x6d 0x20
0x53 0x45 0x33 0x35 0x30 0x20 0x28 0x31 0x55 0x32 0x4e 0x29 0x20 0x20 0x20 0x20 0x20 0x20 0x20
0x20 0x20 0x20 0x20 0x20 0x20 0x20 0x20 0x20 0x20
3. For data security purpose, make sure to disable IPMI again on Lenovo XClarity Controller web interface
or Lenovo XClarity Essentials OneCLI.
If the node is removed from an E1 Enclosure (1U 2-node) and is not to be reinstalled to the E1 Enclosure,
change the vital product data (VPD) to the default mode for proper operation.
https://sysmgt.lenovofiles.com/help/topic/lxpm_frontend/
.)
command, see:
set
.
Chapter 3 Hardware replacement procedures
139