Install The Intrusion Switch Cable - Lenovo ThinkSystem SE350 Maintenance Manual

Step 3. Disconnect the cable from the connector.
Step 4. Carefully lift the intrusion switch carrier out of the server.
Figure 58. Intrusion switch cable removal
Step 5. Press and hold the latches on the both side of the cable.
Step 6. Remove the intrusion switch cable from the carrier.
Figure 59. Intrusion switch cable removal
If you are instructed to return the defective component, please package the part to prevent any shipping
damage. Reuse the packaging the new part arrived in and follow all packaging instructions.

Install the intrusion switch cable

Use this information to install the intrusion switch cable.
Before you install the intrusion switch cable, complete the following steps:
1. Read the following sections to ensure that you work safely.
.
Chapter 3 Hardware replacement procedures
73