Rfid Setup (Commercial Units Only) - Siemens VersiCharge AC Installation And Operation Manual

SECTION 4

RFID Setup (Commercial Units Only)

RFID Cards supported by VersiCharge
Cards Family Memory
MIFARE Classic 1K, 4K
MIFARE Plus 1K, 2K,4K
MIFARE DESFire 2K, 4K, 8K
MIFARE Ultralight 40,48,128,144
RFID functionality is an available feature only for commercial units. Pass the RFID card in front of the RFID and if successful the
Charging Process Light will flash twice from the bottom up and there will be an audible tone. If the card swipe is not successful,
the Charging Process Lights will flash for one second, decreasing to 0.25 second; this will happen two times. There will be two
audible tones, decreasing if the card swipe is unsuccessful.
RFID State Description
RFID swipe successful Charging LED ON/Blinking. White #2, #4, #6 and #8
every 0.25 second in incremental patterns starting
from 0.25 second, 0.50 second, 0.75 second, and
1 second. Repeat 2 times. Audible single beep tone.
RFID swipe not successful Charging LED OFF. White #2, #4, #6 and #8 one second
in decremental pattern, starting from 1 second, 0.75
second, 0.50 second, and 0.25 second. Repeat 2 times.
Audible dual beep tone.
RFID card management can be performed via the Modbus controller, OCPP-based server or by manually using Admin Cards provided
with the unit (note: Admin Cards may not be used when the unit is connected to an OCPP server and RFID cards must be managed by
the OCPP server through the "Local Auth List Management" profile). Please refer to the Modbus map to implement the appropriate
commands to add/remove or authorize charging sessions. VersiCharge maintains a local preauthorized list that holds the list of all
authorized User Cards. An authorized User Card in the preauthorized list will allow the charging session to start when tapped.
To add User Cards to pre-approved, tap Admin Card, followed by tapping the User Card(s) that are to be added to the preauthorized list.
Once all User Cards are added, tap the Admin Card to finish the operation of adding User Cards to local preauthorized list. In order to
remove a User Card from pre-approved, tap the Admin Card followed by the User Card already in the preauthorized list, and then tap
Admin Card again to end the removal process.
Admin Card
NOTE: Admin Cards are only used to add/remove user cards to the system
when RFID is enabled.
Security Protocol Support
Crypto1 ISO14443A Part 1-3
AES, Crypto1 ISO14443A Part 1-4
AES, 3DES ISO14443A Part 1-4
None, 3DES ISO14443A Part 1-3
Installation and Operations Manual VersiCharge™ AC
User Card
NOTE: User Cards are necessary to begin charging when RFID is enabled.
25