Siemens VersiCharge AC Installation And Operation Manual page 10

Electric vehicle charging station

Hide thumbs Also See for VersiCharge AC:

Table of Contents

VersiCharge™ AC Installation and Operations Manual

2.2 Mounting Using a Stud – Recommended Stud Mounting

(use center-top and bottom holes)

Figure 1. Align the mounting bracket and screw into the stud

NOTE: For installation, the mounting-bracket hinges will be pointing to the ceiling and the flat side of the

bracket will be against the wall.

Locate a stud within the wall that can handle the 17+ lb. load of the VersiCharge.

Place the mounting bracket no more than 12" above a 240 V outlet; level the mounting bracket and drill the

center-top hole using a drill with an extender.

Mount the bracket using the top hole and the lag screws, do not tighten all the way.

Level the bracket.

Drill a pilot hole for the center-bottom hole.

Secure with lag screws.

Tighten the top and bottom screws securely using an Allen wrench.

• For concrete cinder block walls, install appropriate anchors. If using an existing outlet, ensure that the power cord

will reach to the outlet. Using a 7/16" socket, attach the mounting bracket to the wall in compliance with NEC® and

local jurisdiction requirements, using the two lag screws provided.

• For Siemens post installation, see the post instruction manual at usa.siemens.com/versichargecommercial.

Table of Contents