Siemens VersiCharge AC Installation And Operation Manual page 11

Electric vehicle charging station

Hide thumbs Also See for VersiCharge AC:

Table of Contents

2.3 Alternate Mounting - Wallboard Mounting (use mounting holes on four corners)

Figure 2. Alternate installation of the VersiCharge mounting

NOTE: For installation, the mounting-bracket hinges will be pointing to the ceiling and the flat side of

the bracket will be against the wall.

NOTE: The VersiCharge can be mounted using 5 #12 x 1-½ LG Phillips head 0.375 head minimum with

five #10 wall anchors.

NOTE: Recommended - The five anchors must be at least 61-lb. anchors rated for 1/2" dry wall.

(Screws and anchors are not included in the kit)

Locate the mounting bracket no more than 12" above a 240 V outlet or if hardwiring, the wiring will come

through the bottom of the charger.

Level the mounting bracket and drill four holes, one in each corner of the bracket.

Place the anchors into the wallboard until they are flush with the wall.

Place the mounting bracket over the holes (with the hinges facing upward and the flat side of the bracket against the wall)

with the anchors and securely screw the mounting to the wall.

Add a fifth hole for mounting the holster once the unit is mounted on the wall. Place the holster on the wall

and mark the correct position for the hole. See Section 2.5 and its graphic.

Installation and Operations Manual VersiCharge™ AC

Table of Contents