Siemens VersiCharge AC Installation And Operation Manual page 14

VersiCharge™ AC Installation and Operations Manual
1. Secure charger to mounting bracket: Using the kit-supplied, tamper-resistant screw, secure the charger cover with one screw
on the side.
2. Install holster to charger: Align the holster with guides in the charger and drill the pilot hole. Using the kit-supplied,
tamper-resistant screw, use the third screw to secure the holster to the charger (the hole at the top of the holster).
3. Standard installation (Figure 5): Drill pilot holes and use the kit-supplied lag screw (#8 x 2-1/2" drywall screw) to secure the
holster to the wall stud.
4. Alternate installation (Figure 2, Section 2.3): Drill pilot holes and use the fifth wallboard screw with anchor to screw into the wall.
2.6 Check the System
1. Turn the power on; the white Power Available light should illuminate. If it does not, verify that the outlet or wire is
putting out 240 V or 208 V using the voltmeter.
2. With the Power Available light on, plug the Electric Vehicle Supply Equipment (EVSE) cable into the car. If you have any
fault lights, please see the LED Light Display table in Section 8.1.
Siemens Sifinity Go mobile app (for installations with 10 or less chargers per account). Download the Sifinity Go
mobile app to your smartphone to get started using your charger. Find these applications at either
Apple App Store.
Siemens Configuration Tool (best used when configuring multiple chargers per account): Download the VersiCharge
Configuration Tool (PC App) at usa.siemens.com/versichargecommercial. Unzip the tool to a PC and install by following the screens.
This tool will allow charger management from a PC.
WARNING! Do not force the connector into the receiver on the vehicle. If the connection
between the receiver and connector shows any resistance, inspect the pins in each. If
damage is found, call a qualified service person.
14
Google Play Store or