Downloading Kit Documents And Hardware Design Files; Board Details - Infineon DEMO FX3 U3V CAM01 EZ-USB FX3 Manual

DEMO_FX3_U3V_CAM01 EZ-USB™ FX3 camera kit guide
Introduction
1.2

Downloading kit documents and hardware design files

The documents and the hardware design files for DEMO_FX3_U3V_CAM01 EZ-USB™ FX3 camera kit can be
downloaded from the kit webpage [3]. The documents include a quick start guide, kit guide (this document),
and release notes. The hardware design files include the schematic, BoM, and layout files.
1.3

Board details

This section lists the key interfaces of the DEMO_FX3_U3V_CAM01 kit.
DEMO_FX3_U3V_CAM01 EZ-USB FX3 camera kit – base board
RESET switch
(SW2)
USB-C connector
(J1)
DEMO_FX3_U3V_CAM01 EZ-USB FX3 camera kit – add-on board
Crosslink FPGA
from Lattice
Semiconductor
(U2)
JTAG Header (J1)
Figure 1 DEMO_FX3_U3V_CAM01 EZ-USB™ FX3 camera kit
Note:
Photos are taken without stand-offs.
1.
The baseboard is mounted with the camera add-on board during manufacturing and delivered pre-mounted
2.
in this kit.
User Guide 4 of 28
GPIO/interface
connector 1 (J5)
USB micro-B
connector (J3)
BOOT mode
switch (SW3)
GPIO/interface
connector 2 (J4)
GPIO/interface
connector 1 (J5)
On-board image
sensor (M1)
Interface for MIPI
camera module
(J3)
GPIO/interface
connector 2 (J4)
002-36189 Rev.*B
2022-12-13