Introduction; Kit Contents - Infineon DEMO FX3 U3V CAM01 EZ-USB FX3 Manual

DEMO_FX3_U3V_CAM01 EZ-USB™ FX3 camera kit guide

Introduction

1 Introduction
The DEMO_FX3_U3V_CAM01 EZ-USB™ FX3 camera kit is based on the FX3 product family of Infineon's
configurable SuperSpeed USB controllers.
FX3 has a fully programmable general programmable interface (GPIF™ II) that can interface with any processor,
ASIC, image sensor or FPGA. It provides easy and effortless connectivity to popular industry interfaces such as
synchronous slave FIFO and image sensor interfaces. The EZ-USB™ FX3 camera kit combines hardware,
software, and documentation that enable customers to evaluate the FX3 device. This user guide describes the
steps to install the software required by the kit and to operate the development board provided with the kit.
This kit is intended to be a solution demo kit for UVC, UAC, and U3V video streaming applications.
See the device datasheets
controllers.
The DEMO_FX3_U3V_CAM01 EZ-USB™ FX3 camera kit supports the following key features:
Video streaming up to 1080p @30fps in YUV format from the onboard image sensor module
•
USB bus-powered operation
•
External off-the-shelf MIPI camera interface from Raspberry Pi
•
Compatible with FX3 explorer kit interconnect boards
•
Onboard regulators
•
Firmware-controlled LED and user switch
•
GPIO headers
•
To view the FX3 controller details, see the webpage.
1.1

Kit contents

The DEMO_FX3_U3V_CAM01 EZ-USB™ FX3 camera kit consists of the following:
Table 1 Kit contents
Item
FX3 baseboard
Camera add-on board
SuperSpeed USB - C cable
Hard copy of quick start guide Documentation
Kit casing
Foam
The following items may be required for developing applications with this kit. Note that the following are not
included in the kit:
Off-the-shelf (OTS) MIPI camera module - MPN# 410-358 from Raspberry Pi
•
22-pin to 15-pin ribbon cable (CAB0306)
•
FX3 explorer kit interconnect boards from Altera and Xilinx
•
User Guide
[4] to understand and compare the various features supported by the EZ-USB™ FX3
Type
Hardware
Hardware
Cable
Package
Package
Comments
To protect and maintain proper placement in the kit
container
3 of 28 002-36189 Rev.*B
2022-12-13