Table of Contents
Advertisement
DEMO_FX3_U3V_CAM01 EZ-USB™ FX3 camera kit guide
Kit operation
9. Click Device control and verify the streaming resolution.
Figure 14
Device control settings
10. Close the eBUS Player to turn off the streaming and put the sticker back on the on-board camera module.
Disconnect the USB-C cable from kit and PC.
5.3
Video streaming from the Raspberry Pi camera
1. Make sure that the kit is programmed with the appropriate firmware image file as mentioned in
2. Disconnect the board from the PC.
3. Disconnect the onboard camera module by lifting the image sensor flex cable connector from J2. Make sure
the flex cable does not touch J2 after lifting.
Note:
Make sure to lift flex cable slowly in such a way that M1 does not come out of the board. Lift the flex
cable such that it only gets disconnected from J2.
User Guide
17 of 28
Table
3.
002-36189 Rev.*B
2022-12-13
Advertisement
Table of Contents
