Table of Contents
Advertisement
DEMO_FX3_U3V_CAM01 EZ-USB™ FX3 camera kit guide
Programming the EZ-USB™ DEMO_FX3_U3V_CAM01 FX3 controller
4
Programming the EZ-USB™ DEMO_FX3_U3V_CAM01 FX3
controller
The EZ-USB™ FX3 controller on the DEMO_FX3_U3V_CAM01 EZ-USB™ FX3 camera kit is pre-programmed with the
latest firmware at the time of manufacturing.
DEMO_FX3_U3V_CAM01 kit is pre-programed with the firmware to stream U3V video from the onboard camera.
Use the USB Control Center application available in the FX3 SDK to change the program.
1. Set switch SW1 on the kit to boot in USB mode as per
2. Connect the kit to the PC using a SuperSpeed USB-C cable.
Figure 5
Kit connected to PC using USB-C cable
3. Open the EZ-USB™ Control Center application. If the application is not present on the desktop, browse to
the FX3 SDK installation directory (C:\Program Files (x86)\Cypress\EZ-USB FX3 SDK).
4. The board should appear as "Cypress FX3 USB Bootloader Device" in the left pane of the USB Control Center
application.
Figure 6
Device enumeration in control center application
User Guide
Table
2.
12 of 28
002-36189 Rev.*B
2022-12-13
Advertisement
Table of Contents
