DEMO_FX3_U3V_CAM01 EZ-USB™ FX3 camera kit guide
Kit operation
5
Kit operation
This chapter describes how to boot the FX3 device after successful programming to demonstrate the kit
functionality by streaming video and audio. Two separate demonstrations are covered:
Streaming video from the onboard camera
•
Streaming video from the off-the-shelf Raspberry Pi MIPI camera
•
Important Note: Before starting the demo, make sure that the kit is loaded with the appropriate firmware per
Table
3.
5.1
Booting from the SPI flash
Set the switch SW3 setting to SPI position as below:
1.
Move SW3 pin 1 to ON position and pin 2 to OFF position.
Figure 8
Mode Switch set to SPI Mode
Power cycle the kit by removing the USB cable from the PC or pressing the RESET switch (SW2).
2.
5.2
Video streaming from the onboard image sensor
Make sure that the kit is programmed with the appropriate firmware image file as mentioned in
1.
Remove the sticker from the onboard camera (M1).
2.
User Guide
14 of 28
Table
3.
002-36189 Rev.*B
2022-12-13