Table of Contents
Advertisement
DEMO_FX3_U3V_CAM01 EZ-USB™ FX3 camera kit guide
Kit operation
4. Connect the Raspberry Pi OV5640 camera module (part# 410-358) to connector J3 on the camera board
using a 15- to 22-pin Raspberry Pi zero camera cable part# CAB0306 as shown below.
Figure 15
Raspberry Pi camera module interface with image sensor board
Note:
Cable and Raspberry Pi camera modules are not part of the kit. Users can buy this directly from the
manufacturer. Cable P/N: CAB0306. Raspberry Pi camera module P/N: 410-358 or equivalent.
5. Move the switch SW1 (1.8 / 3.3 V selector switch) on the baseboard to ON position (3.3 V) and plug in the
SuperSpeed USB-C cable to the PC.
6. Open the eBUS Player app.
7. Click Select/Connect from the eBUS Player. Check if FX3 is detected as shown in
User Guide
18 of 28
Figure
16.
002-36189 Rev.*B
2022-12-13
Advertisement
Table of Contents
