Infineon DEMO FX3 U3V CAM01 EZ-USB FX3 Manual page 11

DEMO_FX3_U3V_CAM01 EZ-USB™ FX3 camera kit guide
EZ-USB™ FX3 camera kit system design
3.3.3 Image sensor connector (J2) and onboard camera module (M1)
The camera add-on board uses a 5-MP MIPI camera module, e-CAM52A_MI5640_MOD from E-Con Systems that
features Omnivison OV5640 CMOS image sensor. This MIPI CSI camera module streams VGA @ 60 fps, HD (720p)
@ 60 fps and full HD (1080p) @ 30 fps. It is an auto focus camera that provides output at YUV422 format. The
camera module is mounted on the image sensor connector assembly present on the add-on board.
3.3.4 Crystal (Y1)
SG-210STF 24.0000ML0 is used to provide 24-MHz clock for the camera module.
3.3.5 External camera module connector for Raspberry Pi (J3)
The camera add-on board allows you to interface external off-the-shelf Raspberry Pi MIPI camera module such
as PCAM-5C. This is a 22-pin FPC connector. You need a 22-pin to 15-pin flex cable (CAB0306) to connect the off-
the-shelf Raspberry Pi MIPI camera module with the DVK camera add-on board.
3.3.6 GPIO interface connectors (J4, J5)
The camera add-on board also has two 20-pin mating interface/GPIO connectors to interface the camera add-
on board with the FX3 baseboard.
Note: Do not connect any external voltage source to these pins as it may permanently damage the kit.
The pins are available only for probing purpose.
User Guide 11 of 28 002-36189 Rev.*B
2022-12-13