Printer Does Not Print - Xerox VersaLink B600 User Manual

P P R R O O B B A A B B L L E E C C A A U U S S E E S S
The printer is connected to a power strip shared with
other high-power devices.
The A A u u t t o o P P o o w w e e r r O O f f f f feature is enabled to save power.
P R I N T E R D O E S N O T P R I N T
P P R R O O B B A A B B L L E E C C A A U U S S E E S S
The printer is in Power Saver mode.
The printer has an error.
The printer is out of paper.
The incorrect paper is loaded for the print job.
The paper settings for the print job do not match any
paper loaded in the paper trays at the printer.
A toner cartridge is empty.
No control panel indicators are lighted.
The printer is busy.
The printer cable is disconnected.
Xerox ® VersaLink ® B600/B610 Printer User Guide
S S O O L L U U T T I I O O N N S S
Plug the printer directly into the outlet or into a power
strip that is not shared with other devices.
Increase the A A u u t t o o P P o o w w e e r r O O f f f f timer setting or disable
the A A u u t t o o P P o o w w e e r r O O f f f f feature. For more information,
refer to the System Administrator Guide at
com/support/VLB600_VLB610docs.
S S O O L L U U T T I I O O N N S S
On the control panel, press the P P o o w w e e r r / / W W a a k k e e button.
If the Status LED is blinking amber, follow the
instructions on the control panel to clear the error. If
the error persists, contact your Xerox representative.
Load paper into the tray.
Load the correct paper in the appropriate tray. At the
printer control panel, specify the correct paper size,
type and color.
From the print driver, select a paper tray containing the
correct paper.
Replace the empty toner cartridge.
Power off the printer, confirm that the power cord is
plugged in correctly to the printer and the outlet, then
power on the printer. If the error persists, contact your
Xerox representative.
• If the Status LED is flashing blue, a previous print
job could be the problem.
1 In the print driver, use the Printer Properties to
delete all print jobs in the print queue.
2 At the control panel, touch J J o o b b s s , then delete all
pending print jobs.
• Load the paper in the tray.
• If the Status LED does not flash once after you
send a print job, check the connection between the
printer and the computer. Power off the printer,
then power on the printer.
If the Status LED does not flash once after you send a
print job, check the connection between the printer
and the computer.
Troubleshooting
www.xerox.
151