Xerox VersaLink B600 User Manual page 171

S S Y Y M M P P T T O O M M
The top margin is incorrect.
The printed surface of the paper is bumpy.
Spots or lines appear at regular intervals on the prints.
Xerox ® VersaLink ® B600/B610 Printer User Guide
S S O O L L U U T T I I O O N N S S
1 Ensure that envelopes are loaded properly in
the Bypass Tray. For more information, refer to
Loading Envelopes in the Bypass
2 Follow the guidelines for printing on envelopes.
For more information, refer to
Printing Envelopes.
3 If the problem persists, use a different size
envelope.
• Ensure that the paper is loaded properly.
• Ensure that the margins are set correctly in the
application that you are using.
• Adjust the paper registration. For more information,
refer to Adjusting Paper
1 Print a solid image over the entire surface of one
sheet of paper.
2 Load the printed sheet into the tray with the
printed side face down.
3 Print five blank pages to remove debris from the
fuser rollers.
1 Print the Repeating Defects pages.
At the control panel, touch D D e e v v i i c c e e > > S S u u p p p p o o r r t t > >
S S u u p p p p o o r r t t P P a a g g e e s s > > R R e e p p e e a a t t i i n n g g D D e e f f e e c c t t s s .
2 To determine the cause of the problem, measure
the distance between the print defects.
• 28 mm (1.1 in.): Drum Cartridge
• 31 mm (1.2 in.): Drum Cartridge
• 42 mm (1.7 in.): Drum Cartridge
• 52 mm (2.0 in.): Drum Cartridge
• 94 mm (3.7 in.): Drum Cartridge
• 46 mm (1.8 in.): Transfer Roller
• 82 mm (3.2 in.): Fuser
• 94 mm (3.7 in.): Fuser
3 If the repeating defects matches one of the
distances, replace the matching component.
Troubleshooting
Tray.
Guidelines for
Registration.
171