OPTEX FA Fastus CD2H Series User Manual page 5

Precautions
„
This product cannot be used in applications that directly or indirectly detect human bodies for the
purpose of ensuring safety. Do not use this product as a detection device for protecting the
human body.
Do not disassemble, repair, modify, deform under pressure, or attempt to incinerate this product.
Doing so may cause injury or fire.
This product does not have a function that stops the emission of light from the laser during
disassembly. Do not disassemble the product.
Do not use this product in water or in a location where it may be exposed to water. Do not use
this product if wet.
Doing so may cause a fire or damage the product.
This product is not explosion-proof and should not be used around flammable or explosive gases
or liquids. Doing so may cause ignition resulting in an explosion or fire.
Do not use air dusters or any spray that uses flammable gas around the product or on the inside
of the product. Doing so may cause ignition resulting in an explosion or fire.
Do not install this product in any of the following locations. Doing so may cause a fire, damage,
or a malfunction.
1. Locations where dust, salt, iron powders, or vapor (steam) is present.
2. Locations subjected to corrosive gases or flammable gases.
3. Locations where oil or chemical splashes may occur.
4. Locations where heavy vibrations or impacts may occur.
5. Locations where the ambient temperature exceeds the rated range.
6. Locations subject to rapid temperature changes (or where condensation occurs).
7. Locations with strong electric or magnetic fields.
8. Locations subject to direct light.
Do not use the product at voltages or with AC power supplies that exceed the rated voltage.
Doing so may cause a fire or damage the product.
This is a class A product. In a domestic environment this product may cause radio interference, in
which case the user may be required to take adequate measures.
This product is not intended for use with nuclear power, railways, aviation, vehicles, medical
equipment, food-handling equipment, or any application where particular safety measures are
required. Absolutely do not use this product for any of these fields.
Do not use this product outdoors. It is specially designed for indoor applications.
Do not look directly at the laser beam or intentionally shine the laser beam in another person's
eyes. Doing so may have adverse affects on the eyes, including temporary blindness.
What to do in the event of a malfunction such as smoke being emitted from the product
If you detect any malfunction including emission of smoke, abnormal smells or sounds, or the
body becoming very hot, immediately stop operating the product and turn off the sensor power.
Failure to do so may cause a fire. Repairing the product is dangerous and should in no way be
performed by the customer. Contact an OPTEX FA sales representative for repairs.
Warning
Safety Precautions
iii