Table of Contents
Advertisement
When the cell phone is successfully paired and
connected to the telephone base, the corresponding
status icon
(
or
) will display. The corresponding device
1
2
light (CELL 1 and/or CELL 2) will turn ON.
The pairing process may take up to one minute. If
the pairing process fails turn the Bluetooth
on your cell phone and the 8084150 OFF by
pressing CELL 1/ CELL 2. Repeat the steps above
to pair and connect again. In some cases it may
take you a few attempts to complete the
pairing process.
The steps for the pairing process may vary for
different cell phones. If this happens follow the
prompts on your cell phone and your 8084150 to
complete the pairing process.
Add a Bluetooth
®
To pair and connect a headset:
1. Press MENU on the phone when it is not in use.
2. Press
to choose Bluetooth, then
or
press SELECT.
3. Press
to choose
or
Add BT headset, then press SELECT. The
screen will display Search headset....
•
If there is already a cell device in the slot the
existing cell phone will be erased from cell
devices list
4. Set your headset to discoverable mode (refer
to the user's manual of your headset on the
Bluetooth
feature of your headset). Once your
®
handset finds your headset press SELECT.
•
Enter the PIN of your headset if required.
The PIN for most Bluetooth
(refer to the user's manual of your headset),
then press SELECT.
5. When the headset is successfully paired and is
connected to the telephone base, the
display. The CELL 2 device light will turn ON.
The pairing process may take up to one minute. If
the pairing process fails, turn the Bluetooth
on your headset and 8084150 OFF by pressing
®
-enabled headset
devices is 0000
®
2
®
CELL 2.
Repeat the steps above to pair and connect again.
In some cases it may take you a few attempts to
complete the pairing process.
When a connected headset is charging, it may
disconnect from the telephone base and the CELL 2
feature
light on the telephone base will turn OFF. For some
headset models you may need to turn the headset
ON and reconnect it to the telephone base.
Auto connection
A cell phone may be disconnected from the
telephone base when:
•
The Bluetooth
phone is turned OFF
•
Your cell phone is turned OFF
•
Your cell phone is not within range of the
telephone base
After the cell phone is disconnected wait for about
1 minute. Turn ON the cell phone, turn ON the
Bluetooth
the base. The base will try to reconnect. If you
disconnect the cell phone from the cell phone list,
the base will not attempt to reconnect unless your
cell phone is moved out of range and back in
range again.
NOTE:
•
If your cell phone does not reconnect to the base
automatically, follow the section below to connect
it manually.
Connect a paired cell phone or headset
If you need to connect your paired cell phone or
headset to the telephone
base manually:
1. Press CELL 1 and/or CELL 2 on the telephone
base when it is not in
use. The CELL 1 and/or CELL 2 light will flash.
icon will
2. When the cell phone or headset is connected to
the telephone base you will hear two beeps. The
corresponding status icon (
feature
The corresponding device light
(CELL 1 and/or CELL 2 ) will turn ON.
16
16
feature of your connected cell
®
feature, or move it within range of
®
/
) will display.
1
2
Advertisement
Table of Contents
