Initial Setup; Headset Connection; Telephone Operation - Bell Excursion 39280 Owner's Manual

UTION: You must use a Class II, 120
Volt AC/9 Volt DC adaptor that delivers
at least 200mA. The center tip must be
positive and the plug must correctly fit
the unit' s DC 9V jack.
1. Plug the AC adaptor into a standard
AC outlet.
2. Insert the small plug inot the DC 9
jack on the rear of the base unit as
shown in Figure 11.
Tone/Pulse
Switch
TONE PULSE
9VDC200mA
LINE
DC 9V
Jack
AC
Adaptor
AC
Adaptor
Plug
( Figure 11)

HEADSET CONNECTION

One of the special features of your
phone is that your handset could utilize a
headset(not included) for hands-free
communication. Insert the small plug at
the end of your headset cord to the
headset jack at the side of the handset as
shown in Figure 12. Follow the
procedures discussed in "Placing a Call"
when to place and receive a call.
Note: The headset jack of your cordless
telephone is compatible with 2.5mm
headset plugs only. When you plug in the
headset into the headset jack, it
automatically mutes the microphone and
speaker of the handset. Unplug the
headset to return the handset to normal
use.
061703A-2
OWNER' S MANUAL # 39280 ver. 061703A-1
Page: 10
Headset
Jack
Telephone
Line Jack

INITIAL SETUP

AC
Outlet
Please follow these steps before using
the cordless telephone for the first time.
1.
2.
Setting the TONE/PULSE Switch
•
•

TELEPHONE OPERATION

Place a Call
1.
2.
ENGLISH VERSION
(Figure 12)
Ensure that the handset battery pack
is installed and charged fully for at
least 12 hours.
Ensure that all connections(line cord
and adaptor cord) are properly
inserted into rear of the base unit.
If your home is equipped with tone-
dialing service set the
TONE/PULSE switch to TONE
position.
If you have a pulse (rotary) dialing
service, set the TONE/PULSE
switch to PULSE position.
Pick up the handset and press the
TALK button. The cordless
telephone will automatically scan
for the best channel available, as
indicated by the flashing IN
USE/BATT LOW LED indicator.
Once it finds a clear channel, the IN
USE/BATT LOW LED indicator
will light solid and a dial tone will
be heard. You can then dial the
10