Supermicro X10DSN-TS User Manual page 62

Chapter 4: AMI BIOS
Wait For 'F1' If Error
Select Enabled to force the system to wait until the <F1> key is pressed when an
error occurs. The options are Disabled and Enabled.
INT19 Trap Response
Interrupt 19 is the software interrupt that handles the boot disk function. When this
item is set to Immediate, the ROM BIOS of the host adaptors will "capture" Interrupt
19 at bootup immediately and allow the drives that are attached to the host adap-
tors to function as bootable disks. If this item is set to Postponed, the ROM BIOS
of the host adaptors will not capture Interrupt 19 immediately to allow the drives
attached to the adaptors to function as bootable devices at bootup. The options
are Immediate and Postponed.
Re-try Boot
Select EFI Boot to allow the BIOS to automatically reboot the system from an EFI
boot device after the initial boot failure. Select Legacy Boot to allow the BIOS to
automatically reboot the system from a Legacy boot device after its initial boot
failure. The options are Disabled, Legacy Boot, and EFI Boot.
Power Configuration
CPLD Watch Dog
Use this feature to determine when CPLD (Complex Programmable Logic Device)
Watch Dog timer will be activated. If this feature is set to Power On, the CPLD
Watch Dog timer will be activated upon system boot and will remain active as long
as the system power is on. If this feature is set to POST, the CPLD Watch Dog timer
will be activated and remain active when the system performs Power-On Self-Test
(POST) routines. If this feature is set to OS, the CPLD Watch Dog timer will be
activated upon OS-boot. The options are Power On, POST, OS, and Disabled.
Power Button Function
This feature controls how the system shuts down when the power button is pressed.
Select 4 Seconds Override for the system to power off after the user presses and
holds the power button for 4 seconds or longer. Select Instant Off to instantly power
off the system as soon as the user presses the power button. The options are 4
Seconds Override and Instant Off.
AC Loss Policy Depend On
Select IPMI for the IPMI to set the power state policy after an AC power outage.
Select BIOS for the BIOS to set the power state policy after an AC power outage.
The options are IPMI and BIOS.
4-5