Supermicro X10DSN-TS User Manual page 16

Super X10DSN-TS Motherboard User's Manual
Peripheral
Devices
BIOS
Power
Management
System
Health
Monitoring
USB Devices
•
Two (2) USB 3.0 ports on the rear I/O panel (USB
0/1)
•
One (1) Type A USB 3.0 connector for front access
(USB 2)
•
16 MB SPI AMI BIOS
•
ACPI 3.0/4.0, USB keyboard, Plug-and-Play (PnP),
Riser card auto detection support, Serial Periph-
eral Interface (SPI), PCI F/W 3.0, BMC GPIO, and
SMBIOS 2.7 or later
•
ACPI Power Management w/S1, S5
•
Power-on mode for AC power recovery
•
Main switch override mechanism
•
Power-on mode for AC power recovery
•
Intel® Intelligent Power Node Manager 3.0 (avail-
able when the Supermicro Power Manager [SPM]
is installed and a special power supply is used. See
the note on Page 1-14.)
•
Management Engine (ME)
System Health/CPU Monitoring
•
Onboard voltage monitoring for +3.3V, 3.3V standby,
+5V, +5V standby, +12V, Vcore VBAT, memory,
PCH, HT, and AOC temperatures (if add-on cards
detected)
•
CPU/system overheat LED and control
•
CPU Thermal Trip support
•
Status monitor for speed control
•
Status monitor for on/off control
•
CPU Thermal Design Power (TDP) support of up to
145W (See Note 1 below.)
Fan Control
•
Fan status monitoring via IPMI connections
•
Single cooling zone
•
Low-noise fan speed control
•
Pulse Width Modulation (PWM) fan control
1-8
SM Flash UEFI BIOS
®