Sos Calling; From Device Ui - Iridium GO! exec User Manual

SOS Calling

Emergency mode (SOS button)
You must configure the Emergency Mode in order for the SOS button to call a
designated Call Recipient. Failure to configure the SOS button will result in no call being
placed when the SOS button is pressed. This could prevent or delay an emergency
response and result in serious injury
or death.
Mode d'urgence (Bouton SOS)
Vous devez configurer le mode d'urgence pour que le bouton SOS envoie un message
d'urgence pour appeler un destinataire d'appel désigné. Si vous ne configurez pas le
bouton SOS, aucun appel ne sera passé lorsque vous appuierez sur le bouton SOS.
Cela pourrait empêcher ou retarder une intervention d'urgence et entraîner des blessures
graves ou la mort.
SOS can be generated in 2 ways, from the device physical SOS button or from the device
UI. User can also access SOS from a phone connected to the Iridium GO! exec app (for
more information, refer to section SOS).

From Device UI

Selecting the SOS icon on the device home screen will display the SOS trigger screen on the
Device. Press and hold the SOS button for at least 3 sec. The Device will begin to play the
pending countdown timer and show the countdown on the screen.
During the countdown period the SOS event may be cancelled without alerting the designated
Emergency Service Provider (ESP). If the call was unsuccessful, the user will get an option to
redial (or to cancel).
The user can then use the device microphone and speaker to converse with the emergency
contact.
Incoming Call on Line 2
when active call on Line 1
45