Table of Contents
Advertisement
Power Drive & Roll-A-Pro
10.2 Clearing the Door Limit Positions
NOTE: If unhappy with the travel limit settting, restart this
procedure by clearing the door limit positions as per below
first.
C L E A R I N G T H E D O O R L I M I T P O S I T I O N S
S T E P O N E
Remove controls cover
S T E P T H R E E
Release
10.4 Re-profiling the Door
R E - P R O F I L I N G T H E D O O R
Re-pro ling is a simple way of re-learning the travel
tip
characteristics of a previously setup Limit Switch
travel. Re-pro ling is used when travel characteristic
change due to mechanical adjustments.
To initiate a re-pro le: LIMITS must already be set.
S T E P O N E
Remove
controls cover
HOLD
for 6 secs
RELEASE
S T E P T W O
Door will open and close
several times
®
installation instructions
S T E P T W O
Till LED
HOLD
ashes quickly
for 6 sec
NOTE: No action taken within
30 secs, the opener returns to
original settings.
Now set Close & Open limits
opener
beeps once
S T E P T H R E E
Then re t
controls cover
opener
beeps once
10.3 Controller memory reset
To clear the controller:
C O N T R O L L E R M E M O R Y R E S E T
If limits are already set, clear limits rst by following
tip
Clearing the door limit positions and then follow
below.
S T E P O N E
Switch power OFF
HOLD
This will cause all control memory to be set to factory defaults
EXCLUDING: transmitters, history log and cycle counters.
10.5 Setting the PET (PEdestrian) mode postion
S E T T I N G T H E P E T M O D E P O S I T I O N
When activated, PET mode drives the door to a
tip
preset position from the close position, therefore
allowing a pet or parcel to go under the door.
S T E P O N E
Remove controls cover
S T E P T H R E E
HOLD
for 6 secs
S T E P F O U R
Re t controls
cover
Release
11
S T E P T W O
till all
LED's off
then
Release
Switch power
ON
S T E P T W O
HOLD
Close to
desired position
+
till both LED's
are lit
Proceed to Storing
the transmitter
Code to code a
remote button to
PET Mode
Hide quick links:
Advertisement
Table of Contents
