Setting The Travel Limits; Initial Preparation - B&D Power Drive RDO-1V4 Installation Instructions Manual

Power Drive & Roll-A-Pro

10. Setting the Travel Limits

10.1 Initial Preparation:

S E T T I N G L I M I T S
When setting the Close limit, ensure the position
tip
is when the door makes rst contact with the
ground. Alternatively for the Open limit the
position should be at the height of the garage
opening.
S T E P O N E
Remove controls cover
S T E P T H R E E
If door opens
Press to change
Press to close
direction
C L O S E L I M I T P O S I T I O N
S T E P O N E
HOLD
Press to close door
RELEASE
W A R N I N G ! I n se t ti n g t he clos e l imit position,
do n ot fo rce th e
exc e s si ve forc e, as t h i s ca n i nter fere w ith the
e as e o f o pera t io n
m ech an i sm .
S T E P T H R E E
If door overshoots
Press to position
Press
®
installation instructions
S T E P T W O
Switch power on
Press to move
door to midway
S T E P T W O
When door near
close, single
presses inch door
CLOSE limit should be
when rubber strip touches
the ground
d o or into the oor with
of t he ma nua l re lease
Press to set
CAUTION: Limit setup is not available when
running on battery backup
O P E N L I M I T P O S I T I O N
S T E P O N E
HOLD
Press to close door
RELEASE
W A R N I N G ! T h e d o o r w i l l a u tom ati c a l ly clo s e.
o p en a n d cl os e a g a i n a f ter t h e n ex t ste p.
E n s u re t h a t n ot h i n g i s i n t h e d oo r 's pa th .
S T E P T H R E E
If door overshoots
Press to position
Press
10
S T E P T W O
When door near
open, single
presses inch door
OPEN limit should be the
height of the garage
opening
Press to set