Safety Testing; Test The Close Cycle; Testing The Open Cycle; Test The Manual Door Operation - B&D Power Drive RDO-1V4 Installation Instructions Manual

Power Drive & Roll-A-Pro

11. Safety Testing

11.1 Test the Close Cycle

a. Press the OPERATE button to open the door.
b. If the door closes, press the OPERATE button to stop the door,
then press OPERATE again to open.
c. Place a piece of timber approximately 40mm high (or the
openers cardboard box) on the floor directly under the door.
d. Press the OPERATE button to close door.
e. The door should strike the object and re-open.
f. Remove the timber or cardboard box.
WARNING! If the door is closing and is unable
to re-open when obstructed, discontinue use.
Do not use a door with faulty obstruction sensing.

11.2 Testing the Open Cycle

a. Press the OPERATE button to close the door.
b. Press OPERATE again to open the door.
c. When the door reaches approximately half way, firmly grab
the door's bottom rail - the door should stop.
If the door does not reverse readily when closing, or stop when
opening, put the door into manual by pulling down on the
manual release string to diesengage the motor and contact
1300 300 625 for support.

11.3 Test the Manual Door Operation

Periodically disengage the opener and manually operate the
door. The door must be smooth to operate by hand. The force
required on the bottom rail should not exceed 20 kg.

11.4 Adjusting Safety Obstruction Force

The Safety Obstruction Force is calculated automatically
during setup. Adjusting this is normally only necessitated by
environmental conditions such as windy or dusty areas, and
areas with extreme temperature changes.

11.5 To Increase Force Pressure

T O I N C R E A S E F O R C E M A R G I N
S T E P O N E
Remove controls
cover
HOLD
S T E P T W O
If LED keeps
ashing, maximum
is reached
®
installation instructions
+
Each press will
increase force &
LED will ash
S T E P T H R E E
RELEASE
Test the force again
as per Testing cycles
CAUTION: Take care when completing a
safety test. Failure to follow this warning
can result in serious personal injury
and/or property damage.
Wood 40mm
high or opener
cardboard box
WARNING! If the door fails these tests,
put the opener into manual mode, only
operate the door by hand and call for
service.

11.6 To Decrease Force Pressure

T O D E C R E A S E F O R C E M A R G I N
S T E P O N E
Remove controls
cover
HOLD
S T E P T W O
If LED keeps
ashing, minimum
is reached
12
+
Each press will
decrease force &
LED will ash
S T E P T H R E E
RELEASE
Test the force again
as per Testing cycles