Table of Contents
Advertisement
ProxyServer User Guide
Introduction
This chapter provides procedures for viewing or changing the configuration of a remote unit.
Remote configuration requires the ProxyServer software to be loaded on the local PC. The local PC
then controls the remote ProxyServer via the LAN.
Remote Configuration
Remote configuration is LAN-based andrequires a Windows Sockets compliant TCP/IP stack. TCP/IP
protocol software that must be installed and functional before the configuration program can be used.
1. You must assign an Internet (IP) address for the PC and for each node that will be managed by
the configuration program. Refer to the protocol software documentation for instructions on how
to set the IP addresses.
Once you have completed this step, you should be able to use the protocol Ping command for
the PC host name. You should also test the network interface configuration by Pinging another
TCP/IP device that is connected to the network.
2. Install the ProxyServer software on the local PC. Once installed click Start | Programs |
ProxyServer 2.10 | Configuration Port Setup.
3. The ProxyServer Port Setup dialog box is displayed.
Verify that the Communication Type field is set to IP.
In the ProxyServer IP Address field, enter the IP Address of the remote ProxyServer.
Click OK when you are satisfied with your selections.
4. The windows Program Manager menu is displayed.
Double-click the ProxyServer Configuration icon.
5. The Reading Configuration. Please wait ... screen is displayed.
80
MTPSR3-200
Advertisement
Table of Contents
