Table of Contents
Advertisement
ProxyServer User Guide
Command:
&Mn
Communications Mode
Values:
n = 0
Defaults:
0
Description: &M0
Asynchronous mode.
&M1
Reserved—responds ERROR.
Command:
&Qn
Asynchronous Communications Mode
Values:
n = 0, 5, or 6
Defaults:
5
Description: &Q0
Asynchronous with data buffering. Same as \N0.
&Q5
Error control with data buffering. Same as \N3.
&Q6
Asynchronous with data buffering. Same as \N0.
Command:
&Sn
Data Set Ready (DSR) Control
Values:
n = 0 or 1
Default:
0
Description: &S0
Force DSR high (on).
&S1
Let DSR follow CD.
Command:
&Tn
Self-Test Commands
Values:
n = 0, 1, 3 or 6
Default:
None
Description: &T0
Abort. Stop any test in progress.
&T1
Local analog loop test.
&T3
Local digital loopback test.
&T6
Remote digital loopback test.
Command:
&V
View Current Configuration
Values:
n/a
Description:
Displays the active modem settings.
Command:
&Wn Store Current Configuration
Values:
n = 0
Default:
None
Description: &W0
Store active modem settings in NVRAM; load them at power-on or following the ATZ command
instead of loading the factory defaults from ROM.
Command:
&Yn
Select Stored Configuration for Hard Reset
Values:
n = 0
Default:
0
Description: &Y0
Select stored configuration 0 on power-up. (For backward compatibility with some software.)
&Y1
Not supported—responds ERROR.
Command: &Zn=x Store Telephone Number
Values:
n = 0, 1, 2, or 3
x = Dialing string
Default:
None
Description:
Stores telephone dial string x in memory location n. Dial the stored number using the command
ATDS=n.
Command:
\Gn
Modem Port Flow Control
Values:
n = 0
Default:
0
Description: \G0
Returns an OK for backward compatibility with some software.
\G1
Not supported—responds ERROR.
Command:
\Jn
Data Buffer Control
Values:
n = 0
Default:
0
Description: \J0
Enable data buffer—serial port speed is independent of connect speed.
\J1
Not supported—responds ERROR.
106
MTPSR3-200
Advertisement
Table of Contents
