Table of Contents
Advertisement
ProxyServer User Guide
Command:
Mn
Monitor Speaker Mode
Values:
n = 0, 1, 2, or 3
Default:
1
Description: M0
Speaker always off.
M1
Speaker on until carrier signal detected.
M2
Speaker always on when modem is off-hook.
M3
Speaker on until carrier is detected, except while dialing.
Command:
Nn
Modulation Handshake
Values:
n = 0 or 1
Default:
1
Description: N0
Modem performs handshake only at communication standard specified by S37 and the B
command.
N1
Modem begins handshake at communication standard specified by S37 and the B command.
During handshake, fallback to a lower speed can occur.
Command:
O
Return On-line to Data Mode
Values:
0, 1, 3
Default:
None
Description: O0
Exit on-line command mode and return to data mode.
O1
Issue a retrain and return to on-line data mode.
O3
Issue a rate renegotiation and return to data mode.
Command:
Qn
Result Codes Enable/Disable
Values:
n = 0 or 1
Default:
0
Description: Q0
Enable result codes.
Q1
Disable result codes.
Command:
Sr=n
Set Register Value
Values:
r = S-register number; n varies
Default:
None
Description:
Set value of register Sr to value of n, where n is entered in decimal format.
Command:
Sr?
Read Register Value
Values:
r = S-register number
Default:
None
Description:
Read value of register Sr and display value in 3-digit decimal form.
Command:
Vn
Result Code Format
Values:
n = 0 or 1
Default:
1
Description: V0
Displays result codes as digits (terse response).
V1
Displays result codes as words (verbose response).
Command:
Xn
Result Code Selection
Values:
n = 0–7
Default:
4
Description: X0
Basic result codes (e.g., CONNECT); does not look for dial tone or busy signal.
X1
Extended result codes (CONNECT 56000 V42bis, CONNECT 33600 V42bis, etc.); does not look
for dial tone or busy signal.
X2
Extended result codes with NO DIALTONE; does not look for busy signal.
X3
Extended result codes with BUSY; does not look for dial tone.
X4
Extended result codes with NO DIALTONE and BUSY.
X5
Extended result codes with NO DIALTONE and BUSY.
X6
Extended result codes with NO DIALTONE and BUSY.
X7
Basic result codes with NO DIALTONE and BUSY.
104
MTPSR3-200
Advertisement
Table of Contents
