Table of Contents
Advertisement
18. The Choose Network Type screen is displayed.
Selections include IPX, NetBIOS, and IP (default is IPX). Click IP and then click Next to
proceed.
19. The COM Port to MCSI Mapping window is displayed.
Click Add Port to add a port to the Local Port list box.
If you want a specific line, click a COM port in the Local Port list box, then click the line to which
you want to map that particular COM Port. The status message "Mapped to MCSI" should
appear above the Local Port list box.
Click Remove Port to permanently remove a port from the Local Port list box.
Click the Unmap button if you want to unmap a line.
Click the Search button to search for lines on a server.
Click the Close button when finished.
At this time Your WINMCSI software installation is complete. Proceed to the next section,
"Running the WINMCSI Workstation Software."
Note: Once MCSI has been installed and configured, make certain that the appropriate modem
drivers are installed on the PC you are configuring. Modem drivers can be found in the "Drivers"
directory on the ProxyServer CD. Modems using a Rockwell chipset need to install using the
5600.inf file. Modems using a Lucent chipset need to install using the 5634ZDX.inf file. If you are not
certain as to the type of chipset in the internal modem, contact Multi-Tech Systems Technical
Support.
MTPSR3-200
Chapter 6 - RAS Dial-Out Redirector
75
Advertisement
Table of Contents
