Ppp, Wakeup-On-Call Parameters; Wakeup-On-Call Configuration Group - Multitech MultiModem MTCBA-G2-EN2 User Manual

Intelligent wireless router
Hide thumbs Also See for MultiModem MTCBA-G2-EN2:
Table of Contents

Advertisement

Chapter 3 – Using the Web Management Software

PPP, Wakeup-on-Call Parameters

The Wakeup-on-Call feature allows the router to wake up and initiate a connection when there is an incoming call
or LAN activity. . The Wakeup-on-Call feature reduces the cost incurred when a router is online and available 24/7.
If you desire some security with this feature, you can set up the router to wake up based on Caller ID or SMS
instead of allowing all incoming calls to wake up the router. Dial-on-Demand in the IP Setup menu must be
enabled for wakeup-on-call features to go into effect.
Note:
When provisioning this feature, you must allow incoming calls, SMS capability, and caller-id.

Wakeup-on-Call Configuration Group

Wakeup on Call:
Enable or disable the Wakeup-on-Call feature. The default is Disable. Wakeup on Call occurs
when a ring or caller ID is detected. This triggers the router to reconnect after the 'Time Delay' expires.
Time Delay:
Enter the amount of time that you want to pass between the reception of a call and the initiation of
the Wakeup-on-Call connection. A time delay is needed to make sure that the incoming call has ended before the
connection is initiated. The default is 10 seconds.
Dial-on-Demand from LAN:
The default is disable. When enabled, the router reconnects when it sees IP traffic on
the LAN is needed to route. If this feature is disabled, Dial-on-Demand initiates a PPP connection to the Internet
only from the WAN, not from the LAN.
44
Multi-Tech Systems, Inc. MultiModem rCell User Guide

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MultiModem MTCBA-G2-EN2 and is the answer not in the manual?

This manual is also suitable for:

Multimodem rcellMtcba-xx-en2Mtcba-xx-en2-gp

Table of Contents