Daylight Configuration Group; Daylight Saving Start Time Group; Daylight Saving End Time Group; Submitting And Saving Your Changes - Multitech MultiModem MTCBA-G2-EN2 User Manual

Intelligent wireless router
Hide thumbs Also See for MultiModem MTCBA-G2-EN2:
Table of Contents

Advertisement

Chapter 3 – Using the Web Management Software

Daylight Configuration Group

Daylight Saving
Enable or disable Daylight Saving mode. The default is Enable.
Daylight Saving
Set the offset to use during Daylight Saving mode. Default is +60 minutes. Enter the time in + /
Offset
- minutes
.

Daylight Saving Start Time Group

Start Ordinal
Set the start ordinal to use during Daylight Saving mode. Options are first, second, third, fourth
and last. Default is second. Daylight Saving time usually starts at the same time on the same day
of the week in the same month every year. Each day of the week occurs four or five times a
month. Therefore, select the week in which daylight saving time starts, either the first, second,
third, fourth or the last of the month.
Start Month
Set the start month to use during Daylight Saving mode. Default is March.
Start Day
Set the start weekday to use during Daylight Saving mode. Default is Sunday.
Start Time
Set the start time to use during Daylight Saving mode. Default is 02:00 (hh:mm).

Daylight Saving End Time Group

End Ordinal
Set the end ordinal to use during Daylight Saving mode. Select the week in which daylight saving
time ends. Options are first, second, third, fourth and last. Default is first.
End Month
Set the end month to use during Daylight Saving mode. Default is November.
End Day
Set the end weekday to use during Daylight Saving mode. Default is Sunday.
End Time
Set the end time to use during Daylight Saving mode. Default is 02:00 (hh:mm).

Submitting and Saving Your Changes

To save your changes, click Submit.
To ensure your changes go into effect, click Save and Restart.

IP Setup, Static Routes Parameters

Networked computers use routing information to identify whether they are sending data packets directly to the
firewall or to another network.
After you define and add a route, you can use the table at the bottom of the group to delete or edit the route.
36
Multi-Tech Systems, Inc. MultiModem rCell User Guide

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MultiModem MTCBA-G2-EN2 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Multimodem rcellMtcba-xx-en2Mtcba-xx-en2-gp

Table of Contents