SMART Board 8084i-G4 Manual
  1. Manuals
  2. Brands
  3. SMART Manuals
  4. Interactive whiteboard
  5. SBID 8084i-G4
  6. Manual

SMART Board 8084i-G4 Manual

Hide thumbs Also See for Board 8084i-G4:
1
2

Advertisement

Table of Contents

See also: User Manual

Important

Before you configure your
SMART Board® 8084i-G4
interactive flat panel
You need to set the computer (or Microsoft® Lync® appliance) input's operating mode to "PC" after
you turn on your SMART Board® 8084i-G4 interactive flat panel for the first time but before you
configure and use the interactive flat panel.
I M P O R T A N T
If you do not complete this procedure, the following could occur:
The interactive flat panel might not display the outer edges of the computer's display.
l
Users might notice higher than normal video display latency.
l
To set the computer input's operating mode to "PC"
1.
Turn on the interactive flat panel.
2.
If you're installing the interactive flat panel as part of a SMART Room System™ for
Microsoft Lync, set the Lync Room Reset option as described in chapter 3 of the
SMART Room System for Microsoft Lync setup and maintenance guide
(smarttech.com/kb/170450).
3.
On the remote control, press INPUT (a), and then press the red button (b),
which is below the BACK button.
The Input Label menu appears.
1
smarttech.com/kb/170597
1022737 Rev 01

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Board 8084i-G4 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for SMART Board 8084i-G4

Summary of Contents for SMART Board 8084i-G4

  • Page 1 You need to set the computer (or Microsoft® Lync® appliance) input’s operating mode to “PC” after you turn on your SMART Board® 8084i-G4 interactive flat panel for the first time but before you configure and use the interactive flat panel.
  • Page 2 © 2013 SMART Technologies ULC. All rights reserved. SMART Board, SMART Room System, smarttech, the SMART logo and all SMART taglines are trademarks or registered trademarks of SMART Technologies ULC in the U.S. and/or other countries. Microsoft and Lync are either registered trademarks or trademarks of Microsoft Corporation in the U.S. and/or other countries. All other third-party product and company names may be trademarks of their respective owners. Contents are subject to change without notice.

Table of Contents