Windscreen Blade Replacement; Brake Pad Bedding - Aston Martin Vantage S 2016 Owner's Manual

Windscreen Blade Replacement

To replace the windscreen wiper blades, the vehicle must be in wiper
service mode.
Set the ignition to position 'I' (ignition OFF and accessories ON).
From the Infotainment system, select <SYSTEM
SETTINGS>ENTER<Wiper service>ENTER. Pressing ENTER then
enables the wiper service mode.
Set the ignition to position 'II' (ignition ON). This moves the wiper
blade arms to the 90° position. Set the ignition to position '0'.
Lift the wiper arm(s) up, press at point (B) and remove the worn wiper
blade(s). Install the new wiper blade(s) and lower the wiper arm(s).
After replacing the wiper blade either:
• Move the vehicle key back through to position 'II' to lower the
wiper arms. Return the vehicle key to position '0' or remove.
• Operate the wiper stalk - the wiper arms will complete the
request and then park.
Brake Pad Bedding-in
Failure to bed-in new brake pads will result in reduced brake
performance and possible brake judder or squeal.
After the installation of new brake pads, brake performance will be
reduced, as the brake discs and pads need to be 'bedded-in'. For the
first few hundred kilometres of new brake pad use, avoid excessive
braking (hard stops from high speed, alpine descents, etc.).
12.11